Watercolor Confetti Dyed Yarn on EGRET

As we head toward the summer, I was wanting to dye up something in a fun mix of colors. I’ve been thinking about crocheting again and had the idea to dye up some yarn with a mix of colors, some softer and some with brighter pops of color throughout. That is how the watercolor confetti yarn was born! A variety of cheerful colors, dyed in short sections perfect for single crochet stitches. I am thinking about making a summery crochet tank top with this yarn and these colors will be perfect!

SUPPLIES

Two skeins EGRET 100% fine organic merino wool

Dharma Trading Co. Acid Dyes in Brilliant Yellow, Peach Blush, Berry Crush, Bright Aqua, True Turquoise, and Electric Violet

Six cups for mixing

Citric acid powder

Six plastic pipettes

Plastic wrap

Large bowl

Gloves

Respirator

Setup for steam setting yarn (link to steam setting blog post)

⅛ teaspoon

 

 

PRESOAK THE YARN

Add a dash of citric acid to the large bowl and fill the bowl two thirds of the way full with cool water. Stir to dissolve the citric acid. Add your two skeins of EGRET to the bowl and allow to presoak until the yarn is fully saturated. This will take about an hour. Once the yarn has been fully saturated, squeeze out all the excess water really thoroughly. The yarn should be damp to the touch but not dripping.

 

PREPARE THE DYE AND DYE SURFACE

While your yarn is presoaking, layout several lengths of plastic wrap on your work surface. If you do not have a dedicated dyeing table like I do, make sure you protect the table with a plastic tablecloth or newsprint before laying down the plastic wrap. This should take 3-4 lengths of plastic wrap that are about two and a half feet long. We will be placing our presoaked yarn on top of the plastic wrap for dyeing and then rolling it up in the wrap to heat set it afterward so you want enough plastic wrap to fully wrap up the dyed yarn.

In six separate cups mix one-eighth teaspoon (1/8 tsp) of each dye color with one-eighth teaspoon (1/8 tsp) of citric acid powder and 3-4 ounces of water. The colors used here are Dharma Trading Co. Acid Dyes in Brilliant Yellow, Peach Blush, Berry Crush, Bright Aqua, True Turquoise, and Electric Violet. 

When working with powdered dyes, make sure to wear gloves and a respirator and that any tools used for dyeing are only used for dyeing as they are no longer food safe. 

Place an eye dropper with each cup of dye solution. 

 

 

ADD THE DYE

After you’ve squeezed out all the excess water, lay the yarn down across the plastic wrap surface you prepared earlier. Spread out the yarn so that it lays in one even layer as much as possible.

Starting with Brilliant Yellow, squeeze the pipette to fill it with the dye solution and use it to spread the dye across the skeins of EGRET evenly in small sections. Aim for one to two-inch sections of dyed yarn. Move the skeins around to make sure the underside of the yarn is dyed as well. 

 

 

Continue dyeing in sections using the pipettes and the premixed dye solution until both skeins are saturated to your liking. I dyed Brilliant Yellow first, followed by Peach Blush with the intention of blending some of the edges of those two colors together for a bit of a watercolor effect. Then I added Berry Crush to the edges of the sections I dyed with the Peach Blush. After that, I filled in the white spaces with Bright Aqua and True Turquoise. Lastly, I filled in any spaces on the edges of the True Turquoise and Berry Crush sections with Electric Violet. I knew the colors were going to spread a little when I heat set them so I wanted to be strategic in what colors I placed next to each other to avoid a muddy mix.

 

 

You can leave a lot of white space if you would like or leave no white space at all! Using the pipettes and steam setting the yarn allows you a great deal of control over color placement. 

 

HEAT SET THE YARN

Roll the dyed yarn up in the plastic wrap that it is sitting on top of starting from one end and rolling straight to the other end. If needed, shift the yarn to the center a little so there is a little bit of plastic wrap on each side so you can tuck the plastic wrap all the way around the yarn. The finished bundle should have all of the yarn fully wrapped in plastic. 

 

 

 

Steam set your yarn.

 

 

RINSE AND DRY YOUR YARN

Once your yarn has set and fully cooled, rinse it thoroughly under cool running water until the water runs clear. Squeeze out the excess water and hang it up to dry. Your freshly hand-dyed yarn is ready to use! I was so excited I went ahead and crocheted up a test swatch. This is 20 stitches of single crochet using a 3.5mm hook.

 

 

Enjoy your beautiful skeins of Watercolor Confetti yarn and tag us on social media so we can see what you made @knomad_yarn We can’t wait to see what you create!